Tt describes various networking tasks and configurations that should be applied to the provided network topology, using Cisco Packet Tracer or a similar network simulation tool. Here are the commands and configurations outlined in the document for each task:
-Create the network design as shown in the pic (please use same devices and links)
-Basic Device Configurations:
For switches and routers:
Set the device name.
Describe each interface.
Assign IPv4 addresses to each interface.
Enable all interfaces.
Test direct links with the ping command.
-VLAN Configurations:
For switches:
Create VLANs (VLAN10 for IT and VLAN20 for HR on one side, VLAN30 for IT and VLAN40 for HR on the other).
Configure access and trunk ports with the appropriate recommendations.
Set up inter-VLAN routing and adhere to the IP addressing scheme shown in the network.
Configure DHCP for each VLAN, paying attention to the Default Gateway.
Test end devices for IP acquisition and connectivity.